Replacement tank LRA 135L Nissan Navara NP300
Couldn't load pickup availability
- 100% secure payment
- Equipment Tested & Approved
- Fast & Careful Shipping
Questions about this Product?
We are here to help you.
The replacement tank LRA is designed for the Nissan Navara NP300 diesel 4WD, in Dual or Extra body style, from 2015 to November 2020. With its capacity to 135 liters, It replaces the original tank in order to increase fuel range for travel, raids, tracks and travel in isolated areas.
This tank is installed on the left side of the driveshaft, retaining the standard exhaust, original filler point, and spare tire. (Page number omitted) LRA specifies that it is suitable for versions with suspension Coil springs helical and bladed. The instructions indicate the removal of the standard tank, the modification of the rear strap hole to 36 mm, and the relocation of the wiring. ABS On the left side, the standard 40mm filler neck was cut, the original pump/gauge assembly was reused, the float arm was lengthened by 40mm, and the heat shield from the standard tank was reattached to the new tank.
Since 1989, LONG RANGE AUTOMOTIVE designs and manufactures its tanks in Australia. Each model is developed for a specific vehicle application to optimize available volume while respecting the chassis's mechanical constraints. The tanks LRA They are made of 2mm T125CQ steel. They incorporate internal baffling to limit fuel movement, as well as an expansion chamber. Before being sold, they undergo pressure tests and several quality control checks. Tests are also carried out over dozens of kilometers of heavily degraded tracks. These tests verify the tank's resistance to vibrations, repeated twisting, impacts, and the stresses of prolonged off-road use.
Technical specifications:
- Type: Replacement tank
- Capacity: 135 liters
- Vehicle compatibility: Nissan Navara NP300 2015 to November 2020
- Compatible engine type: Diesel
- Bodywork: Dual or Extra
- Transmission: 4WD
- System requirements: Suitable until November 2020 only
- Tank replaced: Original tank
- Position: Left side of the drive shaft
- Exhaust: Standard
- Filling point: Standard
- Gauge: Original pump/gauge assembly reused, float arm to be extended by 40 mm
- Spare wheel: Retained
- Special compatibilities: Suspension Coil springs helical and bladed confirmed
- Special compatibilities: Filling may require modification if a flatbed skip is installed
- Estimated assembly time: 3 hours
- Made in Australia
