Replacement tank LRA 130L Volkswagen Amarok V6
Couldn't load pickup availability
- 100% secure payment
- Equipment Tested & Approved
- Fast & Careful Shipping
Questions about this Product?
We are here to help you.
The replacement tank LRA is designed for the Volkswagen Amarok TDI550 / TDI580 V6 diesel 4WD, in Dual body style, from 2017 to 2022. With its capacity to 130 litersIt replaces the original tank to increase fuel range for travel, raids, tracks and travel in isolated areas.
This tank is installed on the left side of the driveshaft, retaining the standard exhaust, original filler point, and spare wheel. The instructions describe removing the standard tank, reusing the original pump/gauge assembly, adapting the float arm, relocating the rear axle breather, protecting the differential lock wiring, moving the wiring harness to the left side, fitting a 530 mm filler hose, and drilling a front mounting hole in the crossmember. If a flatbed skip is installed in place of the original skip, filling may require modification.
Since 1989, LONG RANGE AUTOMOTIVE designs and manufactures its tanks in Australia. Each model is developed for a specific vehicle application to optimize available volume while respecting the chassis's mechanical constraints. The tanks LRA They are made of 2mm T125CQ steel. They incorporate internal baffling to limit fuel movement, as well as an expansion chamber. Before being sold, they undergo pressure tests and several quality control checks. Tests are also carried out over dozens of kilometers of heavily degraded tracks. These tests verify the tank's resistance to vibrations, repeated twisting, impacts, and the stresses of prolonged off-road use.
Technical specifications:
- Type: Replacement tank
- Capacity: 130 liters
- Vehicle compatibility: Volkswagen Amarok TDI550 / TDI580 V6 2017 to 2022
- Compatible engine type: Diesel
- Bodywork: Dual
- Transmission: 4WD
- System requirements: V6 model only
- Tank replaced: Original tank
- Position: Left side of the drive shaft
- Exhaust: Standard
- Filling point: Standard
- Gauge: Original pump/gauge assembly reused, float arm to be adapted
- Spare wheel: Retained
- Specific compatibilities: TDI550 from 2017 to 2020; TDI580 from 2021 to 2022
- Specific incompatibilities: Not compatible with the NF model
- Estimated assembly time: 3.9 hours
- Made in Australia
