Replacement tank LRA 120L Nissan Navara D22
Couldn't load pickup availability
- 100% secure payment
- Equipment Tested & Approved
- Fast & Careful Shipping
Questions about this Product?
We are here to help you.
The replacement tank LRA is designed for the Nissan Navara D22 petrol or diesel 4WD, in Single or Dual body style, from June 1999 to 2015 depending on the version. With its capacity to 120 litersIt replaces the original tank to increase fuel range for travel, tracks, raids and travel in isolated areas.
This tank is installed on the right side of the driveshaft, with the standard exhaust and original filler neck retained. The spare tire remains in place. The page LRA specifies that if a flatbed skip is installed, filling may require modification, with additional labor time. The instructions indicate the removal of the standard tank, the reuse of the original gauge and strainer, the reinstallation of the vent valve, the temporary disconnection of the rear drive shaft and the installation of new secondary tank supports.
Since 1989, LONG RANGE AUTOMOTIVE designs and manufactures its tanks in Australia. Each model is developed for a specific vehicle application to optimize available volume while respecting the chassis's mechanical constraints. The tanks LRA They are made of 2 mm T125CQ steel. They incorporate internal baffles to limit fuel movement, as well as an expansion chamber. Before being sold, they undergo pressure tests and several quality control checks. Tests are also carried out on dozens of kilometers of heavily degraded tracks. These tests make it possible to verify the resistance of the tank to vibrations, repeated twisting, impacts and the stresses of prolonged off-road use.
Technical specifications:
- Type: Replacement tank
- Capacity: 120 liters
- Vehicle compatibility: Nissan Navara D22 June 1999 to 2015
- Compatible engine type: Petrol or diesel
- Bodywork: Single or Dual
- Transmission: 4WD
- Tank replaced: Original tank
- Position: Right side of the drive shaft
- Exhaust: Standard
- Filling point: Standard
- Gauge: Original gauge reused
- Spare wheel: Retained
- Special compatibilities: Filling may require modification if a flatbed skip is installed
- Estimated assembly time: 3 hours
- Made in Australia
